Zitat
Original von Anthony in NZ aus "1/32 BK-117 B2 "Westpac Rescue" Detailed build"
Thank you very much!
Well this week I decided I needed a change of pace so decided to do the intake scoops on the engine cowl.
So I tried my hand at vac-forming...........it took a little practice, but here is what I did
This shape gave me 2 ends (2 scoops) and I measured up the positions on the cowl and cut the openings. I then trimmed the vac part up and poked it up through the hole.
I need to tidy up around the edge where it pokes through the opening, but otherwise I think it will be ok. I just have the ones on the side to do next.
Cheers and thanks for looking
Anthony
Dieser Beitrag wurde bereits 1 mal editiert, zuletzt von »kutscha« (22. Februar 2010, 10:30)
Dieser Beitrag wurde bereits 1 mal editiert, zuletzt von »Merzbrücker« (8. März 2010, 17:33)
Dieser Beitrag wurde bereits 1 mal editiert, zuletzt von »Benbenton« (14. März 2010, 14:53)
Forensoftware: Burning Board®, entwickelt von WoltLab® GmbH